[Free] 2018(June) Dumps4cert Cisco 300-101 Dumps with VCE and PDF Download 1-10

Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 May Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco IP Routing

Question No: 1 – (Topic 1)

A network administrator uses IP SLA to measure UDP performance and notices that packets on one router have a higher one-way delay compared to the opposite direction. Which UDP characteristic does this scenario describe?

  1. latency

  2. starvation

  3. connectionless communication

  4. nonsequencing unordered packets

  5. jitter

Answer: A

Question No: 2 – (Topic 1)

Which three problems result from application mixing of UDP and TCP streams within a network with no QoS? (Choose three.)

  1. starvation

  2. jitter

  3. latency

  4. windowing

  5. lower throughput

Answer: A,C,E

Question No: 3 – (Topic 1)

Under which condition does UDP dominance occur?

  1. when TCP traffic is in the same class as UDP

  2. when UDP flows are assigned a lower priority queue

  3. when WRED is enabled

  4. when ACLs are in place to block TCP traffic

Answer: A

Question No: 4 – (Topic 1)

Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?

  1. dual-stack method

  2. 6to4 tunneling

  3. GRE tunneling

  4. NAT-PT

Answer: A

Question No: 5 – (Topic 1)

Which statement about the use of tunneling to migrate to IPv6 is true?

  1. Tunneling is less secure than dual stack or translation.

  2. Tunneling is more difficult to configure than dual stack or translation.

  3. Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts.

  4. Tunneling destinations are manually determined by the IPv4 address in the low-order 32 bits of IPv4-compatible IPv6 addresses.

Answer: C

Question No: 6 – (Topic 1)

Which switching method is used when entries are present in the output of the command show ip cache?

  1. fast switching

  2. process switching

  3. Cisco Express Forwarding switching

  4. cut-through packet switching

Answer: A

Question No: 7 – (Topic 1)

Which two actions must you perform to enable and use window scaling on a router? (Choose two.)

  1. Execute the command ip tcp window-size 65536.

  2. Set window scaling to be used on the remote host.

  3. Execute the command ip tcp queuemax.

  4. Set TCP options to quot;enabledquot; on the remote host.

  5. Execute the command ip tcp adjust-mss.

Answer: A,B

Question No: 8 – (Topic 1)

A network administrator executes the command clear ip route. Which two tables does this command clear and rebuild? (Choose two.)

  1. IP routing

  2. FIB

  3. ARP cache

  4. MAC address table

  5. Cisco Express Forwarding table

  6. topology table

Answer: A,B

Question No: 9 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

A network administrator checks this adjacency table on a router. What is a possible cause for the incomplete marking?

  1. incomplete ARP information

  2. incorrect ACL

  3. dynamic routing protocol failure

  4. serial link congestion

Answer: A

Question No: 10 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

Based on this FIB table, which statement is correct?

  1. There is no default gateway.

  2. The IP address of the router on FastEthernet is 209.168.201.1.

  3. The gateway of last resort is 192.168.201.1.

  4. The router will listen for all multicast traffic.

Answer: C

100% Dumps4cert Free Download!
Download Free Demo:300-101 Demo PDF
100% Dumps4cert Pass Guaranteed!
Download 2018 Dumps4cert 300-101 Full Exam PDF and VCE

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.