[Free] 2018(Aug) Ensurepass Cisco 200-401 Dumps with VCE and PDF 21-30

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 200-401
100% Free Download! 100% Pass Guaranteed!

Managing Industrial Networks with Cisco Networking

Question No: 21 DRAG DROP – (Topic 2)

Ensurepass 2018 PDF and VCE


Ensurepass 2018 PDF and VCE

Question No: 22 – (Topic 2)

What is the purpose of Spanning Tree Protocol?

  1. to prevent routing loops

  2. to create a default route

  3. to provide multiple gateways for hosts

  4. to maintain a loop-free Layer 2 network topology

  5. to enhance the functions of SNMP

Answer: D

Question No: 23 – (Topic 2)

EtherNet/IP is an Ethernet implementation of which protocol?

  1. CIP

  2. Industrial Protocol

  3. DeviceNet

  4. ControlNet

Answer: A

Topic 3, Install, Replace, and Remove Cables

Question No: 24 – (Topic 3)

Which option best describes a mechanical, ingress, climatic, chemical and electromagnetic environment that is classified as M3 I3 C3 E3?

  1. the highest quality

  2. office environment

  3. severe

  4. serviced by multiple cable segments

Answer: C

Question No: 25 – (Topic 3)

With what are APC connectors used?

  1. Category 6a cables that need tight radius bends

  2. copper network cables in corrosive environments

  3. single-mode fiber-optic cables to reduce return loss

  4. high-density copper patch panels

Answer: C

Question No: 26 – (Topic 3)

What should be done with unused conductors in copper unshielded or shielded twisted-pair network cables?

  1. terminate in their characteristic impedance

  2. trim back and properly insulate

  3. connect to protective earth

  4. splice to a used conductor

Answer: A

Question No: 27 – (Topic 3)

Which characteristic causes multimode fiber-optic cable to differ from single mode?

  1. by allowing multiple network services in the same cable

  2. shorter maximum network segment length for a given bandwidth

  3. a wider variety of available connector types

  4. use outdoors as well as indoors

Answer: B

Question No: 28 – (Topic 3)

For which three issues should fiber-optic network segments be tested? (Choose three.)

  1. attenuation

  2. near-end crosstalk

  3. length

  4. polarity

  5. jitter

  6. tensile stress

Answer: A,C,D

Topic 4, Troubleshooting

Question No: 29 – (Topic 4)

You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?

  1. router#ping

  2. router#tracert

  3. router#show ip route

  4. router#show cdp neighbors

  5. router#traceroute

Answer: E

Question No: 30 – (Topic 4)

At which Layer would you check for spanning tree loops?

  1. Layer 1

  2. Layer 2

  3. Layer 3

  4. Layer 4

Answer: B

100% Ensurepass Free Download!
200-401 PDF
100% Ensurepass Free Guaranteed!
200-401 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.