[Free] 2018(Jan) EnsurePass Testinsides VMware 2V0-622 Dumps with VCE and PDF 31-40

Ensurepass.com : Ensure you pass the IT Exams
2018 Jan VMware Official New Released 2V0-622
100% Free Download! 100% Pass Guaranteed!

VMware Certified Professional 6.5 – Data Center Virtualization (6.5) Exam

Question No: 31

An administrator cannot enable multi-processor Fault Tolerance (SMP-FT) for a virtual machine.

Which are two possible causes for this? (Choose two.)

  1. The virtual machine is running on a vSAN datastore.

  2. The Fault Tolerance network is using a 10Gbit uplink.

  3. The virtual machine has 6 vCPUs assigned.

  4. The virtual machine has a 1TB VMDK attached.

  5. The virtual machine has snapshots present.

Answer: C,E

Question No: 32

An administrator is using virtual machine encryption in their vSphere 6.5 environment. The Key Management Server (KMS) has experienced a critical failure.

Which two statements are true about VM encryption when the KMS is not available? (Choose two.)

  1. VMs will shut down gracefully in the event of a KMS outage as a proactive measure to prevent data theft.

  2. VMs which were running at the time of the KMS failure will continue to run.

  3. If an ESXi host is rebooted,it will be unable to power on encrypted VMs until KMS connectivity is restored.

  4. vCenter Server will continue to distribute encryption keys as long as it is not rebooted while the KMS is unreachable.

  5. ESXi hosts within the same cluster will share keyswith one another while the KMS is unreachable.

Answer: B,C

Question No: 33

Which two statements are true about Permanent Device Loss (PDL)? (Choose two.)

  1. All paths are shown asDeadfor the affected device.

  2. The datastore cluster is incorrectly configured.

  3. Thedatastore on the affected device shown a yellow warning sign.

  4. The datastore on the affected device shows a red error sign.

  5. The operational state of the affected device changes toLost Communication.

Answer: A,B

Question No: 34

An administrator notices that a host is evacuating all virtual machines and entering maintenance mode even though the host appears to be up and running.

Which new feature in vSphere 6.5 would cause this?

  1. Predictive DRS

  2. EVC Mode

  3. vCenter HA

  4. Proactive HA

Answer: C

Question No: 35

Which are the two network requirements for a VMware vSAN 6.5 cluster? (Choose two.)

  1. Multicast must be enabled on the physical switches and routers that handle vSAN traffic.

  2. vSAN requires IPv6 only.

  3. All hosts must have a dedicated 40GbE NIC.

  4. The vSAN network supported IPv4 or IPv6.

  5. vSAN requires IPv4 only.

Answer: A,D

Question No: 36

An administrator has enabled vSphere Distributed Switch Health Check. The hosts connected to that Distributed Switch all display an alert:

vSphere Distributed Switch MTU supported status

The administrator has all of the VMkernel ports MTU sizes set to 1600. Which action will remedy this problem?

  1. Configure the Distributed Switch to MTU 9100.

  2. Disconnect and reconnect the physical network cable.

  3. Configure the physical switch to MTU 1600.

  4. Disable the Distributed Switch MTU.

Answer: A

Question No: 37

An administrator wishes to enable network port mirroring based on source port. Which feature should be enabled?

  1. vSphere standard switch port


  3. NSX Virtual Wire

  4. VLAN

Answer: D

Question No: 38

Which two partitions are used for the VMware vCenter Server Appliance embedded vPostgres database? (Choose two.)

  1. /storage/seat/

  2. /storage/netdump/

  3. /storage/db/

  4. /storage/core/

Answer: C,D

Question No: 39

Which two encryption keys does the host use when encrypting virtual machine files? (Choose two.)

  1. Public Key Infrastructure Encryption Key (PKI)

  2. Master Encryption Key (MEK)

  3. Data Encryption Key (DEK)

  4. Key Encryption Key (KEK)

Answer: C,D Explanation:

Referencehttps://pubs.vmware.com/vsphere- 65/index.jsp?topic=/com.vmware.wssdk.pg.doc/PG_VM_Encryption.14.2.html

Question No: 40

An ESXi host’s VMCA-Signed certificate has expired. How can the certificate be renewed?

  1. In the vSphere Web Client, browse to the host in question. Click the Manage tab and select settings. Select System and click Certificate, then click the Renew button.

  2. In the vSphere Web Client, browse to the host in question.Click the Manage tab and select settings. Select System and click Certificate, then click the Refresh CA Certificates button.

  3. Run the command /sbin/generate-certificates on the affected host.

  4. Disconnect the host from vCenter Server and reconnect it.

Answer: B

100% Ensurepass Free Download!
Download Free Demo:2V0-622 Demo PDF
100% Ensurepass Free Guaranteed!
2V0-622 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.